Table of Contents
Advertisement
OPERATING INSTRUCTIONS
vmo2008-011-027_c
Note: On the X xc model, pulling the
tether cord clip out of the tether stop
switch will also stop the engine.
Post-Operation Care
When vehicle is used in salt-water en-
vironment, rinsing the vehicle with
fresh water is necessary to preserve
vehicle and its components. Metallic
parts lubrication is highly recommend-
ed. Use XP-S Lube (P/N 293 600 016)
or an equivalent. This must be per-
formed at the end of each operating
day.
When vehicle is operated in muddy
conditions, rinsing the vehicle is rec-
ommended to preserve vehicle and its
components and to keep lights clean.
Note: Never use a high pressure
washer to clean the vehicle USE LOW
PRESSURE ONLY (like a garden
hose). The high pressure can cause
electrical or mechanical damages.
What to Do if Vehicle Is
Turned Over
When vehicle is turned over or stays
tilted on the side, put the vehicle back
on its wheels, then wait 3 to 5 minutes
before starting the engine.
______________
66
MAINTENANCE INFORMA-
Refer to
TION
and inspect the following.
– Inspect air filter housing drain tube
for oil accumulation, if any oil is
found, clean air filter and air filter
housing.
– Check engine oil level and refill if
necessary.
– Check engine coolant level and refill
if necessary.
What to Do if Vehicle Is
Immersed in Water
Should the vehicle become immersed,
it will be necessary to take it to an au-
thorized Can-Am dealer as soon as pos-
sible. NEVER START THE ENGINE!
NOTICE
Immersion of the vehi-
cle can cause serious damage if the
correct restart procedure is not fol-
lowed.
Hide quick links:
Advertisement
Table of Contents
