Through - ICON weider 8515 WESY87150 User Manual

As you assemble the cables and pulleys in
steps 14 through 22, please refer to the
CABLE DIAGRAM on page 22 of this manual.
14. Route the Long Cable (23) around the 3 1/2Ó
Pulley (15) attached to the Top Frame (55).
Be sure that the end of the Cable with the
ball is on the indicated side of the Pulley
and that the Cable is between the Pulley
and the hook on the Top Frame. Tighten the
3/8Ó x 3 3/4Ó Bolt (71) and the 3/8Ó Nylon
Locknut (not shown).
15. Wrap the Long Cable (23) around a ÒVÓ-Pulley
(6). Attach the ÒVÓ-Pulley and a Long Cable
Trap (50) to the indicated bracket on the
Front Upright (42) with a 3/8Ó x 2 1/2Ó Bolt (7)
and a 3/8Ó Nylon Locknut (21).
Route the Long Cable (23) around the ÒVÓ-
Pulley (6) on the Left Arm (47). Tighten the
3/8Ó x 2 1/2Ó Bolt (7) and the 3/8Ó Nylon
Locknut (not shown). Be sure that the Cable
is in the groove of the Pulley and that the
Long Cable Trap (50) is turned to hold the
Cable in place.
10
14
55 23
71
Ball
15
Hook
15
7
50
23
6
7
42ÑBracket
21
6
50
47
25. Press a 1 1/2Ó Square Inner Cap (32) into the
Leg Lever (29).
Lubricate the 5/16Ó x 2 1/4Ó Bolt (33). Attach
the Leg Lever (29) to the Seat Frame (36)
with the 5/16Ó x 2 1/4Ó Bolt and a 5/16Ó Nylon
Locknut (3).
Insert the 5/16Ó x 2Ó Eyebolt (35) into the Leg
Lever (29) from the direction shown. Tighten
a 5/16Ó Nylon Locknut (3) with a 5/16Ó Flat
Washer (8) onto the Eyebolt.
26. Rest the Seat Frame (36) on the indicated pin
in the Front Upright (42). Attach the Seat
Frame to the Front Upright with a 5/16Ó x
2 3/4Ó Carriage Bolt (14) and the Seat Knob
(40).
27. Press 3/4Ó Round Inner Caps (34) into the
ends of both 12 1/2Ó Pad Tubes (28).
Insert one 12 1/2Ó Pad Tube (28) into the
Seat Frame (36). Slide a 5 1/2Ó Pad (30) onto
each end of the Pad Tube.
Insert the other 12 1/2Ó Pad Tube (28) into the
Leg Lever (29). Slide a 5 1/2Ó Pad (30) onto
each end of the Pad Tube.
15
25
36
3
33ÑLubricate
29
8
35
32
3
26
40
36
14
Pin
42
27
34
30
36
28
29
30
34