Page 1
If you have questions, or if there are missing parts, please contact us: Call: 08457 089 009 From Ireland: 00 (44) 53 9236102 Website: www.iconsupport.eu E-mail: csuk@iconeurope.com Write: ICON Health & Fitness, Ltd. c/o HI Group PLC Express Way Whitwood West Yorkshire WF10 5QJ CAUTION...
To reduce the risk of serious injury, read all important precautions and instructions in this manual and all warnings on your weight bench before using your weight bench. ICON assumes no responsibility for personal injury or property damage sustained by or through the use of this product.
All manuals and user guides at all-guides.com BEFORE YOU BEGIN Thank you for selecting the WEIDER PRO 120 weight reading this manual, please see the front cover of this ® bench. The weight bench offers a selection of exer- manual. To help us assist you, note the product model cises designed to develop the major muscle groups of number and serial number before contacting us.
All manuals and user guides at all-guides.com PART IDENTIFICATION CHART This chart is provided to help you identify the small parts used in assembly. The number in parentheses below each part refers to the key number of the part from the PART LIST near the end of this manual. IMPORTANT: If you cannot find a part in the hardware kit, check to see if it has been preassembled.
All manuals and user guides at all-guides.com ASSEMBLY To make assembly easier, carefully read the • The following tools (not included) may be required following information and instructions: for assembly: two adjustable wrenches • Assembly requires two persons. one rubber mallet •...
Page 7
All manuals and user guides at all-guides.com 2. Press two 50mm Round Outer Caps (9) onto the Pivot Leg (2). Align the indicated hole in the Pivot Leg (2) with the middle adjustment hole in the Frame (1). Align these holes Attach the Pivot Leg (2) to the Frame (1) with the M10 x 70mm Bolt (14) and the M10 Locknut...
Page 8
All manuals and user guides at all-guides.com 4. Attach the Bench (12) to the Frame (1) with two M6 x 48mm Screws (4) and two M6 x 16mm Screws (5). 5. Make sure that all parts are properly tightened before you use the weight bench. The use of all remain- ing parts will be explained in ADJUSTMENT, beginning on page 9.
All manuals and user guides at all-guides.com ADJUSTMENT The weight bench is designed to be used with your own weight set (not included). The steps below explain how the weight bench can be adjusted. Refer to the accompanying exercise guide to see the correct form for several exercises.
All manuals and user guides at all-guides.com PART LIST—Model No. WEEVBE7023.0 R0310A Key No. Qty. Description Key No. Qty. Description Frame Pad Tube Pivot Leg Lock Pin Adjustment Leg Bench M6 x 48mm Screw M10 Locknut M6 x 16mm Screw M10 x 70mm Bolt Foam Pad L-pin...