Registering An Access Point Using The Wps Function - Sony PXW-Z150 XDCAM Operating Manual

Priority Connection
Select whether to configure connection
priority for access points.
z Tip
• Selecting [DNS server setting] on the IP
ADDRESS SET screen will display the DNS
server setting screen.
6
Select [Register].
• Connection to the access point is
initiated.
• [Registered.] appears when the access
point is registered successfully. The
SSID of the registered access point is
also displayed.
7
Select , and press the
t
MENU button to close the menu
screen.
Registering an access point
using the WPS function
You can register an access point quickly if
the access point supports the WPS function.
1
Turn on the access point.
2
Turn on the camcorder.
3
Press the MENU button.
4
Select (NETWORK SET) t
[Wi-Fi SET] t [WPS] with the V/v /
B/b /SET button.
• After a short delay, the following
screen appears.
5
Press the WPS button of the
access point within the next two
minutes.
• For details about the WPS button
function, refer to the manual for the
access point.
• Connection to the access point is
initiated.
• [Registered.] appears when the access
point is registered successfully. The
SSID of the registered access point is
also displayed.
• A message is displayed on the screen
if the access point could not be
connected. Select [OK], then repeat
the procedure after selecting [WPS] in
step 4.
6
Select , and press the
t
MENU button to close the menu
screen.
b Notes
• For details about the functions and settings
supported by your access point, refer to the
manual for the access point or contact the access
point administrator.
Continued ,
83