Sony PXW-Z150 XDCAM Operating Manual page 21

2
Connect the DC plug to the DC IN
jack of the camcorder.
3
Connect the power cord (mains
lead) to the AC Adaptor and the
wall outlet (wall socket).
4
Turn the ON/STANDBY switch to
STANDBY (1 ).
The CHG lamp lights up and charging
starts.
When charging ends
The CHG lamp turns off when the battery is
fully charged.
Disconnect the AC Adaptor from the DC
IN jack.
z Tip
• You can check the remaining battery life with
the status check function (p. 69).
To remove the battery pack
Turn the ON/STANDBY switch to
STANDBY (1 ). Press and hold the BATT
RELEASE button, and slide the battery up
and out.
BATT RELEASE button
To store the battery pack
If the battery pack is not in use for a while,
run down the battery and store it (p. 138).
Charging time
Approximate time (minutes) required when
you charge a fully discharged battery pack.
Battery pack Full charge time
NP-F770 420 minutes
NP-F970 600 minutes
(sold separately)
Continued ,
21