Audio Setup; Recording Sound From The Internal Microphone - Sony PXW-Z150 XDCAM Operating Manual

Audio setup

The jacks, switches and dials shown below
allow you to set the sound that is recorded.
See page 9 for details about connecting a
microphone.
External audio input and selection
A : INPUT1 jack
B : INPUT2 jack
C : INPUT1 (LINE/MIC/MIC+48V)
switch
G : INPUT2 (LINE/MIC/MIC+48V)
switch
Audio source switches
D : CH-1 (INT MIC/EXT/MI SHOE)
switch
H : CH-2 (INT MIC/EXT/MI SHOE)
switch
Audio level controls
E : AUTO/MAN (CH-1) switch
I : AUTO/MAN (CH-2) switch
F : AUDIO LEVEL (CH-1) dial
J : AUDIO LEVEL (CH-2) dial
Recording sound from the
internal microphone
You can record sound in stereo using the
camcorder's internal microphone.
Internal Internal microphone
1
Set the CH-1 (INT MIC/EXT/MI
SHOE) switch D and CH-2 (INT
MIC/EXT/MI SHOE) switch H to
"INT MIC."
z Tips
• If the audio level is too low, set [INT MIC
SENS] to [HIGH].
• To reduce wind noise, set [INT MIC WIND] to
[ON].
• If the internal microphone is selected for both
channels 1 and 2 (CH-1: INT MIC, CH-2: INT
MIC), the sound that is output from the
headphones during recording and standby will
have weaker stereo effect than the sound that is
actually recorded.
Continued ,
45