Table of Contents
Advertisement
Priority Connection
Select whether to configure connection
priority for access points.
z Tip
• Selecting [DNS server setting] on the IP
ADDRESS SET screen will display the DNS
server setting screen.
6
Select [Register].
• Connection to the access point is
initiated.
• [Registered.] appears when the access
point is registered successfully. The
SSID of the registered access point is
also displayed.
7
t
Select
MENU button to close the menu
screen.
Registering an access point
using the WPS function
You can register an access point quickly if
the access point supports the WPS function.
1
Turn on the access point.
2
Turn on the camcorder.
3
Press the MENU button.
, and press the
4
Select
(NETWORK SET) t
[Wi-Fi SET] t [WPS] with the V/v/
B/b/SET button.
• After a short delay, the following
screen appears.
5
Press the WPS button of the
access point within the next two
minutes.
• For details about the WPS button
function, refer to the manual for the
access point.
• Connection to the access point is
initiated.
• [Registered.] appears when the access
point is registered successfully. The
SSID of the registered access point is
also displayed.
• A message is displayed on the screen
if the access point could not be
connected. Select [OK], then repeat
the procedure after selecting [WPS] in
step 4.
6
Select
t
MENU button to close the menu
screen.
b Notes
• For details about the functions and settings
supported by your access point, refer to the
manual for the access point or contact the access
point administrator.
, and press the
83
Continued ,
Advertisement
Table of Contents
