Belly Panel; Exhaust System; Cargo Box (Xt/Xtx) - Arctic Cat 2009 Prowler XT Service Manual

CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean the floor with soap and water.
2. Inspect the floor for cracks or holes.
INSTALLING
1. Place the front of the floor into position in the
vehicle first; then lower the rear and push past the
seat lock studs.
2. Secure the floor with twelve cap screws and two
self-tappings screws.
3. Install the center console and seats making sure
the seats lock securely into position.

Belly Panel

REMOVING
1. Remove the body screws securing the belly panel
to the underside of the frame.
2. Remove the belly panel.
INSTALLING
1. Place the belly panel into position on the underside
of the frame.
2. Install the body screws. Tighten securely.
Back
PR165
Back to TOC

Exhaust System

REMOVING MUFFLER
1. Remove the two exhaust springs at the muf-
fler/exhaust pipe juncture.
2. Slide the muffler assembly clear of the holder pins.
INSPECTING MUFFLER
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Inspect muffler externally for cracks, holes, and
dents.
2. Inspect the muffler internally by shaking the muf-
fler back and forth and listening for rattles or loose
debris inside the muffler.
NOTE: For additional details on cleaning the muf-
fler/spark arrester, see Section 2.
INSTALLING MUFFLER
1. Place the muffler onto the holder pins and slide
into position.
2. Secure the muffler to the exhaust pipe with the two
exhaust springs.
Cargo Box
(XT/XTX)
REMOVING
1. Raise the cargo box; then remove the cap screw
and nut securing the lower lift support to the
frame. Account for the washer. The cargo box will
tilt fully rearward.
Back to Section TOC
PR131
8
Next
8-13