Carburetor (650 Cc) - Arctic Cat 2009 Prowler XT Service Manual

INSTALLING
1. Lightly lubricate the O-ring on the choke body;
then carefully insert the choke assembly into the
carburetor being careful not to damage the
plunger.
2. Secure the choke with the screw and tighten
securely; then connect the choke connector to the
wiring harness.
Carburetor
KEY
1. Cover
2. Screw
3. Spring
4. Vacuum Piston
5. Spring Seat
6. Jet Needle
7. Needle Jet
8. Jet Holder
9. Main Jet
10. Slow Jet
11. Starter Jet
12. Float Valve
13. Clip
! WARNING
Whenever any maintenance or inspection is per-
formed on the fuel system during which there may
be fuel leakage, there should be no welding, smok-
ing, open flames, etc., in the area.
REMOVING
1. Remove the seats and center console; then remove
the left-side seat-base.
2. Loosen the clamps on the inlet boot; then remove
the boot from the left-side.
Back
(650 cc)
14. Float Set 27. Float Chamber
Assy
15. Float Pin
28. Screw
16. Pilot Screw
29. Spring
17. Spring
30. Diaphragm Assy
18. Washer
31. Pump Housing
19. O-Ring
32. U-Ring
20. Idle Adjust Screw
33. Screw
21. Washer
34. O-Ring
22. Spring
35. Screw
23. Plate
36. Screw
24. Screw
37. Cover
25. Electric Choke
38. Vent Hose
26. Choke Cover
Back to TOC
3. Loosen the clamp securing the intake boot to the
carburetor; then separate the carburetor from the
boot.
4. Remove the gas hose and carburetor float chamber
vent hose.
5. Remove the throttle arm cover; then loosen the
outer jam nut on the throttle cable and disconnect
the throttle cable from the carburetor.
0741-115
6. Disconnect the electric choke connector; then
remove the carburetor from the engine.
DISASSEMBLING
1. Remove the four Phillips-head screws securing the
top cover; then remove the cover.
Back to Section TOC
PR160A
4
PR154A
PR162A
Next
4-3