Prowler/XT/XTX
(Table of Contents)
Removing Engine/Transmission.............................. 3-3
Removing Engine/
Transmission
Many service procedures can be performed without
removing the engine/transmission from the frame.
Closely observe the note introducing each sub-section
for this important information.
AT THIS POINT
If the technician's objective is to service/replace
left-side cover oil seals, front output joint oil seal,
rear output joint oil seal, and/or the oil strainer (from
beneath the engine/transmission), the engine/trans-
mission does not have to be removed from the
frame.
Support the vehicle on a suitable lift or jack stands
allowing room to perform work from the underside.
NOTE: Locate the jack stands to allow removing
of the center belly panel.
! WARNING
Make sure the vehicle is solidly supported on the
support stands to avoid injury.
1. Remove the seats and center console; then remove
the left-side and right-side seat-bases.
2. Remove the center belly panel; then drain the oil
and coolant.
Back
Back to TOC
NOTE: Use a small funnel between the frame and
coolant drain plug to prevent coolant from drain-
ing on the frame and splashing.
3. Remove the negative cable from the battery; then
remove the positive cable.
4. From the left-side, remove the spark plug cap;
then disconnect the temperature sensor lead, speed
sensor connector, fuel level sensor connector, and
reverse override switch connector.
Back to Section TOC
PR122A
3
PR156A
PR130A
Next
3-3