Fuel Level Sensor (650 Cc) - Arctic Cat 2009 Prowler XT Service Manual

2. Start the engine. Fuel pump pressure should show
0.036-0.084 kg/cm
REMOVING
1. Remove the right-side seat-base; then remove the
three clamps securing the gas hoses and vacuum
hose and disconnect the hoses.
2. Remove the two machine screws and flange nuts
securing the fuel pump to the electrical tray; then
remove the pump.
INSTALLING
1. Place the fuel pump into position on the electrical
tray; then secure with the machine screws and
flange nuts. Tighten securely.
2. Connect two gas hoses and one vacuum hose; then
secure with the clamps.
Fuel Level Sensor
REMOVING
1. Remove the seats and the center console; then
remove the right-side seat-base.
Back
(0.5-1.2 psi).
2
(650 cc)
Back to TOC
2. Remove the gasline hose and disconnect the fuel
level sensor connector; then remove four
torx-head machine screws and the fuel level sensor
mounting plate.
CD815
3. Remove the fuel level sensor from the gas tank.
Account for a seal.
INSPECTING
1. Inspect the fuel screen and clean with low pressure
compressed air.
2. Move the float lever and check for free movement.
The float assembly should drop to the "empty"
position when the fuel level sensor is held verti-
cally. If there is binding or sticking, replace the
fuel level sensor.
3. Test the fuel level sensor by connecting a multime-
ter (A) to the fuel level sensor connector (B); then
select OHMS on the multimeter. The multimeter
should read 5 ohms of resistance at "full fuel"
position (C) and 95 ohms at the "empty fuel" posi-
PR280A
tion (D).
NOTE: If readings are erratic, clean the resistor
wiper and resistor with a clean cloth soaked with
alcohol and retest. If the readings shown are not
as specified, replace the fuel level sensor assem-
bly.
Back to Section TOC
PR166C
4
ATV2116
Next
4-19