3. Install the rear hold-down strap joining cap screw
and nut. Do not tighten at this time.
4. Place the gas cap filler panel into position; then if
necessary, position the gas tank so the filler panel
and filler neck are not binding or rubbing.
5. Secure the filler panel with four press-nuts; then
tighten the hardware securing the hold-down
straps (from steps 2-3) securely.
Back
PR171
PR166A
PR176
Back to TOC
6. Connect the gas hose and gas tank vent hose to the
proper fittings; then connect the fuel level sensor
connector to the main harness.
7. Position the floorboard into the vehicle and secure
with the appropriate hardware; then install the cen-
ter console, seat-bases, and seats making sure the
seats lock securely.
Gas/Vent Hoses
Replace the gas hose every two years. Damage from
aging may not always be visible. Do not bend or
obstruct the routing of the carburetor vent hose (XT).
Make certain that the vent hose is securely connected
to the carburetor and the opposite end is always open.
Back to Section TOC
PR166A
4
PR167A
PR166B
Next
4-11