Pen Parameters (Only With Hp-Gl And D-Scan) - Oki LP-2050-MF User Manual

Setup Items in PDL Setting Menu
T
Chapter
1
‹ Pen Parameters (only with HP-GL and D-SCAN)
Chapter
2
n
Chapter
3
Chapter
4
Chapter
5
132
LP-2050/LP-2050-MF User's Manual for Basic Printer Operation
Pen parameters specify the Printer's drawing pen conditions, e.g., thickness (line
width), and density.
HP-GL: 00 to 15
D-SCAN: 01 to 32
Pen Settings
z
Pen Parameter Mode
The parameter selects the data setting or touchpanel setting tospecify the pen
attribute.
<Parameter by selecting options>
Data Setting
n
Panel Setting
z
Fine Pen-Width Adjustment
The parameter adjusts the pen width value. The pen width specified with data or
touchpanel setting is increased or decreased by the adjustment value.
Note that the maximum pen width is 16 mm (0.63 inches), and the minimum is 1 dot.
<Parameter by selecting options>
-0.99 to +0.99
z
Micro-Vector Rounding
The parameter specifies the shape of the micro-vector's line ends and line joins.
<Parameter by selecting options>
Off
n
On
With the Printer, micro-vector is defined as follows:
z
- The line width and line length are 1 mm or less.
: Default value
n
Enables the data setting for the pen attributes.
Enables the touchpanel setting for the pen attributes.
Default value = 0
: Default value
n
Line end is specified by the Line End parameter, and Line
join is specified by the Line Join parameter.
Performs rounding for all micro-vectors.