Format Parameters (Only With Hp-Gl And D-Scan) - Oki LP-2050-MF User Manual

Setup Items in PDL Setting Menu
T
Chapter
1
‹ Format Parameters (only with HP-GL and D-SCAN)
Chapter
2
Chapter
3
Chapter
4
n
Chapter
5
126
LP-2050/LP-2050-MF User's Manual for Basic Printer Operation
Format parameters specify the analysis conditions in the HP-GL format and D-SCAN
format.
Select this setting to:
- Use the LP-2050's printer driver;
- Operate without the touchpanel setting; and
- Print on a user defined series roll.
The user-defined roll width is specified with:
- The printer driver setting; or
- The touchpanel setting
When you intend to specify a user-defined roll width with the printer driver setting,
set the parameter to User Defined.
However, in spite of selecting User Defined, the user-defined roll width with touchpanel
setting is valid when the Printer receives data from the other printer drivers.
Printer Drive (only with HP-GL)
The parameter specifies the operation mode for the LP-2050's printer driver.
When the LP-2050's printer driver is operated with other drivers, set the parameter
to Enabled.
<Parameter by selecting options>
Not Enabled
Enabled
n
: Default value
n
When the Printer operates with the printer driver for LP-1030
installed, select Not Enabled to prioritize the PDL settings
with the operation panel over the driver settings.
Note
When the driver is disabled, some items are
‹
affected.
Items affected by the driver settings are listed in
the table on the following page.
When the Printer operates with the printer driver for LP-2050
installed, select Enabled to prioritize the driver settings over
the PDL settings with the operation panel.
However, when the Printer receives data from the other
printer driver, the PDL settings with the operation panel is
prioritized.