Interrupt Control (Sprung Position); Automatic Stop-Start; Operation Overview; Start Control - Skoda SUPERB Owner's Manual

Note to reduce speed
If the delay of the ACC is insufficient in relation to the vehicle in front, the
warning light lights up in the instrument cluster and the display shows a

message to engage the brake pedal.
Regulation according to the vehicle in the adjacent lane
During regulation your vehicle may be regulated according to the vehicle in the
adjacent lane.
This could occur at speeds above about 80 km/h when your vehicle is moving
faster than the vehicle in the adjacent lane on the driver's side. The display
shows the detected vehicle is in the adjacent lane.
Note
Some ACC notifications in the display of the instrument cluster may be hidden
by notifications for other functions. An ACC notification automatically appears
for a brief moment when there is a change in status of the ACC.

Automatic stop-start


Read and observe on page 148 first.
Vehicles with an automatic transmission can decelerate to a standstill and
start moving again using the ACC.
Decelerate to a standstill
If a vehicle ahead decelerates to a standstill, the ACC will also decelerate your
vehicle to a standstill.
Starting to drive again after a holding period
As soon as the vehicle ahead starts moving again after a holding period, your
vehicle will also move and the speed will continue to be regulated.
If the preceding vehicle starts moving again after a long break, then to contin-
ue the regulation press the accelerator pedal or lever to position ad-
just» page

150, Operation overview.

150
Driving
Operation overview
Fig. 194 Operating lever

Read and observe on page 148 first.
Overview of ACC functions operated with the lever
Activate ACC (regulation deactivated)
1

Start control (resume) / increase speed by 1 km/h at a time
2

(sprung position)

Interrupt control (sprung position)

3 
Deactivate ACC
4

Increase speed by 10 km/h at a time
5
 
Decrease speed by 10 km/h at a time
6
 
   Set proximity level
A
Start control / reduce speed in increments of 1 km/h
B

If the lever is set from the position  directly into the sprung position, 
the current speed is stored and the control process is started.

Start control


Read and observe on page 148 first.
Basic requirements for start of control
The ACC is activated.

On vehicles with manual transmission, the second gear or a higher gear is

selected and the current speed is greater than 25 km/h.
On vehicles with automatic transmission, the selector lever is in the D/S

position or in the Tiptronic position.
» Fig. 194
