Advertisement
OPERATING GUIDELINES
SPECIFICATION
B. TEMPERATURE CONTROL
1. Turn the power ON. Display will show the words "On".
2. After a few seconds the display would show a number between 200
to 480 indicating the set temperature.
3. The display would then switch to showing the actual temperature.
4. To Increase the temperature, turn the Temperature control knob
clock wise. To decrease Set temperature, turn the Temperature con-
trol knob counter clockwise. The display would revert to showing
the set temperature while the control knob is being adjusted.
5. When the desired temperature has been set, let go of the the tem-
perature control knob. The display would then revert to showing the
actual temperature after a few seconds.
C. SLEEP FUNCTION
1. The Soldering Iron is equipped with a vibration sensor.
2. When the soldering iron has been left unmoved the system would
begin countdown for the sleep timer.
3. Sleep timer is configurable via the ff. method.
Upon switching ON the unit, gently shake the soldering iron pen
◆
to enter into the sleep timer configuration mode.
When the system has entered into sleep timer configuration
◆
mode, the display would change to "t##" (where ## represents
the sleep time)
Adjust the sleep time by turning the temperature control knob
◆
clockwise to increase timer and counterclockwise to decrease
timer.
"t00" signifies that the sleep timer is turned OFF. Therefore unit
◆
will never go into sleep mode.
Sleep timer is adjustable from 10 to 60 minutes.
◆
The system will automatically save the settings after the control
◆
knob has been left unmoved for a few seconds.
8
保养
SAFETY PRECAUTIONS
CAUTION:
Improper usage can cause serious injury to personnel and/or
damage to equipment and work area. For your own safety, please observe
the following precautions.
Check each component after opening the package to make sure
●
everything is in good condition. If there are any suspected dam-
age, do not use the item and report the issue to your vendor.
Turn OFF the main power switch and unplug the device from
●
power source when moving the device.
Do not strike or subject the main unit (and all its components) to
●
physical shock. Use carefully to avoid damage to any part.
Handle with care.
●
- Never drop or sharply jolt the unit.
- Contains delicate parts that may break if the unit is dropped.
Make sure the equipment is always grounded. Always connect
●
power to a grounded receptacle.
Temperature may reach as high as 480°C when switched ON.
●
- Do not use the device near flammable gases, paper and other flammable
materials.
- Do not touch heated parts, which can cause severe burns.
- Do not touch metallic parts near the tip.
Disconnect the plug from the power source if the unit will not be
●
used for a long period.
- Turn off power during breaks, if possible.
Use only genuine replacement parts.
●
- Turn off power and let the unit cool down before replacing any part.
The unit may produce a small amount of smoke and unusual odor
●
during initial usage. This is normal and should not yield any nega-
tive result when reworking.
Soldering process produces smoke — use on well ventilated places.
●
Do not alter the unit, specifically the internal circuitry, in any man-
●
ner.
5
Advertisement
