Problem Solving - CAME V700E Installation Manual

- To clean the photocells use a water dampened cloth. Do not use solvents or other chemical products which may ruin the devices.
- In the event of any strange vibrations or squeaking, lubricate the joints with grease, as shown in the diagram.
- Make sure there are no plants within the photocell's beam, and that the heavy door motion is free of any obstacles.

10.2 Problem solving

MALFUNCTIONS
The automation does not open nor close
The automation opens but does not close
The automation closes but does not open
The automation does not automatically close
The remote control does not work
The automation exerts too much force
The automation exerts too little force
The automation inverts the direction of movement
Only one remote control works
The photocell does not work
The led indicator flashes quickly
The led indicator stays on
The led power-on indicator is off
The automation does not work with the
emergency batteries
The automation inverts the direction of movement
at the end of the cycle
The automation starts slowly
REFERENCES CHECKS
1-3 1 - Check the power supply and the line fuses
4-10-23 3 - The N.C. (1-2) safety contact is open
23 4 - The N.C. (2-C1) safety contact is open
9-10 5 - The N.C. safety contacts are open
12-14 6 - Deactivate the obstruction detection function using the dip-
switches
16 9 - Check that the A.C.T. trimmer is not set to minimum
16-17-23-24 10 - Check the proper direction of motion
16-17-23-24 11 - N.C. command button instead of N.O.
18 12 - Check the fuse bridge on AF43S, remove/put power back on
4-19 14 - Memorise the radio code again
4-25-26 16 - Ad just the sensitivity using the TRIMMER
11 17 - Eliminating mechanical friction
3-1 18 - Insert (or duplicate) the same code in all the remote controls
6-21-22 19 - Check the proper functioning of the photocell
10-17-23 21 - Check the batteries
17-23-24 22 - Respect the polarity of the photocells and accessories
23 - Checking the balancing of the overhead door
24 - Checking the tension of the belt/chain
25 - Encoder multifunctioning: cut off and give back power to the card
26 - Erroneous Encoder connection: check the connections