Printronix SL5000 User Manual page 329

Table 17. LCD Message Troubleshooting (continued)
Displayed Message
FAN WARNING
FILE EXISTS
Enable Overwrite
FILE SYS FULL
Add Flash
FILE SYS FULL
Delete Files
FILE SYS FULL
Optimize & Reboot
FILE SYS INVALID
Optimize&Reboot
FILE SYS WRITE
Check Flash
Can User
Explanation
Correct?
Yes The printer detected
that the power supply
fan did not rotate for at
least 45 seconds when
it is was supposed to.
NOTE: This is a
warning message and
will not halt printing.
When too high of
internal temperature is
detected, based on its
source, the printer will
stop printing and
display a PWR
SUPPLY HOT,
PRINTER HOT or
PRINT HEAD HOT
message.
Yes The printer operator
tried to save a file
using the name of an
existing stored file.
Yes/No Insufficient flash
memory available to
store file.
Yes Insufficient flash
memory available to
store file.
Yes Insufficient flash
memory available to
store file.
Yes/No File system not
detected or flash was
corrupted.
Yes/No Problem writing to flash
memory.
Fault Messages
Solution
1. Verify that the fan rotates
when the printer is first
powered up and when the
printer moves media or
prints.
2. Call your authorized
service representative.
Enter the PRINTER
CONTROL menu and enable
the Overwrite Files feature to
overwrite the existing file.
Install a larger flash memory
SIMM. For additional flash,
contact your authorized service
representative.
Enter the PRINTER
CONTROL menu. Use Delete
Files to delete unwanted files.
Enter the PRINTER
CONTROL menu and use the
Optimize & Reboot feature.
Enter the PRINTER
CONTROL menu and use the
Optimize & Reboot feature.
Power off the printer for 15
seconds, then power back on.
If the problem persists, contact
your authorized customer
service representative.
329