Printronix SL5000 User Manual page 114

Chapter 3
QUICK SETUP
NOTE: If you save a configuration with the validator enabled, then power
If the validator is installed, the default is Enable.
Active IGP Emulation
See page 150 for more details.
xxx Diagnostics
See page 151 for more details.
Save Config.
This option allows you to save up to eight unique configurations to meet
different print job requirements. This eliminates the need to change the
parameter settings for each new job. The configurations are stored in memory
and will not be lost if you turn off the printer. If the Protect Configs. parameter
is enabled, the new configuration will not be saved unless the existing
configuration has been deleted first. The factory default configuration cannot
be changed. See "Saving A Configuration" on page 88 for details.
The factory default is 1.
Power-Up Config.
You can specify any one of nine configurations (1-8 saved custom
configurations or Factory) as the power-up configuration.
The factory default is Factory.
SMT:Status
You can enable or disable SMT functionality.
PAA: Select Tool
You can set the PAA:Select Tool to None (the default), CST-1, or CST-2.
Refer to the PrintNet Enterprise Suite User's Manual .
114
down and power up, and the validator is not connected or not
functioning, the error message "Validator not communicating" will
display briefly. The Validator menu will not display.