Printronix SL5000 User Manual page 222

Chapter 3
PA1
PA1 is only valid when the printer is in the offline state and the coax Systems
Network Architecture Character Set (SCS) data stream is active. This function
displays the "PA1 ENABLED" message when the ENTER key is pressed, and
sends a special operator request to the host when the printer is put back
online. Refer to the Coax/Twinax Programmer's Reference Manual for more
information about SCS.
NOTE: Selecting PA1 again ("PA1 DISABLED" appears on the operator
PA2
PA2 is only valid when the printer is offline and the coax SCS data stream is
active. This function displays the "PA2 ENABLED" message when the ↵ key is
pressed, and sends a special operator request to the host when the printer is
put back online.
NOTE: Selecting PA2 again ("PA2 DISABLED" appears on the operator
Page Rotation
This option rotates the physical IPDS page.
The options are 0, 90, 180, and 270.
The factory default is 0.
PDF Size Comp
This option is for compatability of the font size of the barcode printable data
field on the old build.
•
Enable. Matches the font size of the old build.
•
Disable. Uses the normal font size.
The factory default is Disable.
PGL Normal
This option determines whether PGL passes the text data in Normal mode
according to LP+ or whether PGL will print the text data itself.
•
LP+ Menu (the default). PGL will pass the text data to LP+ only in the
default setting state (6 LPI, default character set, and font attribute).
•
PGL Menu. PGL will always print the text data itself.
PI Slew Range
You can specify how many lines the paper will feed.
•
15. A paper slew of 1-15 will move 1-15 lines. A paper slew of 0 will move
1 line.
•
16 (the default). A paper slew of 0-15 will move 1-16 lines.
222
panel) or selecting PA2 will reset the pending PA1 function.
panel) or selecting PA1 will reset the pending PA2 function.