Printronix SL5000 User Manual page 266

Chapter 3
WLAN PARAMS
SSID Name
A 1-32 character, case-sensitive string that identifies the Extended Service
Set Identification (ESS_ID) network the unit is part of. (ESS_ID is also called
NET_ID.) These characters can be alphanumeric, symbols, or spaces.
Reset SSID Name
Allows you to reset the SSID name.
Min Xfer Rate
Allows you to set the minimum speed at which the Wireless Option will accept
a connection (in millions bits per second). The options are Auto-negotiate,
1Mb/sec., 2Mb/sec., 5.5Mb/sec., and 11Mb/sec.
The factory default is Auto-negotiate.
Channel
Allows you to select the RF channel.
The options are Default (the factory default) and 1-15.
Ant. Diversity (802.11b only) or Antenna (802.11b/g)
The RF antenna to use:
•
Diverse (the default). Select when you want to use the antenna with the
best reception. (802.11b only)
•
Primary. Select when you want to use the Primary antenna on the RF
card. (802.11b and 802.11 b/g) Default setting for 802.11b/g.
•
Auxiliary. Select when you want to use the Auxiliary antenna on the RF
card. (802.11b and 802.11 b/g)
Preamble
The length of the preamble in transmit packets.
•
Default (the default). The Wireless option automatically determines the
length.
•
Short. For newer printers which can handle higher transfer rate speeds.
•
Long. For older printers, which cannot handle higher transfer rate
speeds.
Power Mgmt
This allows you to set power-save mode and sleep time. A value specifying
the sleep time in milliseconds will be provided. If set to zero, power-save
mode will be disabled.
The range is 0-1000 ms., and the factory default is 0 ms.
266