Install Processor Heatsink; Install Memory Modules - Intel R1000RP Series Quick Installation

General Installation Process
6

Install Processor Heatsink

CAUTION: The heatsink has thermal interface
material (TIM) on the underside of it. Use caution so
that you do not damage the thermal interface material.
Use gloves to avoid sharp edges.
A
Remove the protective film on the TIM if present.
B
Align heatsink fins to the front and back of
the chassis for correct airflow.
Airflow goes from front-to-back of chassis.
Each heatsink has four captive fasteners and
should be tightened in a diagonal manner using
the following procedure:
Using a #2 Phillips* screwdriver,
C
start with screw 1 and engage screw
threads by giving it two rotations
and stop. (Do not fully tighten.)
D
Proceed to screw 2 and engage screw
threads by giving it two rotations and
stop. Similarly, engage screws 3 and 4.
E
Repeat steps C and D by giving each
screw two rotations each time until
each screw is lightly tightened up to
a maximum of 8 inch-lbs torque.
Install Memory Modules ...continued
Memory Configurations and Population Order:
For the best performance, a minimum of three DIMMs per CPU is recommended,
populated in the blue slot of each memory channel.
Note: For additional memory configurations, see the Service Guide on the
Intel Server Deployment & Management DVD that accompanied
®
your Intel Server System, or go to:
®
http://www.intel.com/p/en_US/support/ (post-production)
Memory sizing and configuration is supported only for qualified DIMMs approved by
Intel . For a list of supported memory, go to:
®
http://serverconfigurator.intel.com/sct_app.aspx (post-production)
Install DIMM Memory Modules ... Continued
To Install DIMMs:
A
Open both DIMM socket levers.
B
Note location of alignment notch.
C
Insert DIMM making sure the connector edge of the DIMM aligns correctly with the slot.
D
Push down firmly on the DIMM until it snaps into place and both levers close.
E
IMPORTANT! Visually check that each latch is fully closed and correctly engaged with each DIMM edge slot.
CAUTION:
Do not
over-tighten
fasteners.
B
3
D
2
E
4
TIM
A
Note: Heatsink styles may vary.
CAUTION: Avoid touching contacts
when handling or installing DIMMs.
4
7

Install Memory Modules

DDR3L DIMM Memory Identification:
CAUTION: Observe normal ESD (ElectroStatic
Discharge) procedures to avoid possible damage to
system components.
This server board supports up to 6 DDR3L 1333/1600
ECC UDIMM. Non-ECC memory is NOT supported by
this server board.
DIMM notch and socket bump must align as shown below.
C
1
DDR3
Intel Server Board S1200V3RPM
®
CPU Socket
E
D
A
Other
Memory
C
B