Duct Kit Assembly; Unit Diffuser Assembly - L.B. White TS080 Owner's Manual

1. Extend duct kit to 12 ft./3.65 m. length.
2. See Fig. 9 for installation of duct. Hand tighten the
screws snugly. (Note: Slots are also provided at the
sides of heater's air discharge to accomodate earlier
style duct adapters with tab mounting configuration.)
3. Position duct as shown. Eliminate any kinks in duct.
1. See Fig. 10 for installation of unit diffuser. Hand tighten
the screws snugly. (Note: Slots are provided to
accomodate earlier style unit dif fusers with tab
mounting.)
2. Position the diffuser under the tent wall as shown. Lay
the tent material within the channel of the diffuser.
Ensure the material is securely anchored within the
channel to prevent contact with the heater. See below
for typical installation.
FIG. 9
EARLIER STYLE DUCTING
SLOTS FOR INSTALLING
EARLIER STYLE DUCTING
FIG. 10
MATERIAL LOCATED IN CHANNEL
AND SECURELY ANCHORED TO
PREVENT CONTACT WITH HEATER
BEFORE TIGHTENING WING
SCREWS INTO CAGE NUTS

DUCT KIT ASSEMBLY

Accessory 26346
INSTALL TAB AT BOTTOM OF COLLAR
INTO SLOT AT BOTTOM OF OUTLET
BEFORE FASTENING WING SCREWS
UNIT DIFFUSER
Accessory 26349 (Premier 80)
& 26351 (Premier 170)
WING SCREW
SLOT
INSERT TAB AT BOTTOM
OF DIFFUSER INTO SLOT
FASTEN WING SCREWS
INTO CAGE NUTS AT
BLOWER OUTLET AND
TIGHTEN
CAGE NUTS
12