Hose And Regulator Assembly Instructions - L.B. White CV100 Owner's Manual And Instructions

9. Light according to instructions on heater or within
owner's manual.
10. Make sure the heater has the proper gas regulator for
the application. A regulator must be connected to the
gas supply so that gas pressure at the inlet to the gas
valve is regulated within the range specified on the
dataplate at all times. Contact your gas supplier, or
the L.B. White Co., Inc. if you have any questions.
11. This heater can be configured for use with either
propane gas vapor withdrawal or natural gas. Consult
the heater's dataplate for the gas configuration of the
specific heater. Do not use the heater in an propane
liquid withdrawal system or application. If you are in
doubt, contact the L.B. White Co., Inc.
HOSE AND REGULATOR ASSEMBLY
1. Always use approved pipe thread compound suitable
for use with propane gas or natural gas on the
threaded connections.
2. Assemble the components together according to the
figure. This view is to show general assembly of the
components only.
3. Tighten all connections securely.
4. Check a a ll c c onnections f f or g g as l l eaks u u sing a a pproved
gas l l eak d d etectors.
8
12. Take time to understand how to operate and maintain
the heater by using this Owner's Manual. Make sure
you know how to shut off the gas supply to the
building and also to the individual heater. Contact
your fuel gas supplier if you have any questions.
13. Any defects found in performing any of the service or
maintenance procedures must be eliminated and
defective parts replaced immediately. The heater
must be retested by properly qualified service
personnel before placing the heater back into use.
FIG. 1
PROPANE GAS SUPPLY
REGULATOR
HOSE ADAPTER
CONTAINER VALVE
HOSE