QuickLabel Systems pronto! 486 User Manual page 243

Error message
Remove ribbon
Structural err.
Unknown card
USB error
Device stalled
USB error
Too much current
USB error
Unknown device
Voltage error
Write error
Write protected
Wrong revision
Pronto! 482/486/682/863
Cause
Transfer ribbon is loaded
although the printer is set
to direct thermal printing
Error in directory of the
memory card, non-secure
data access
Memory card not
formatted
Memory card type not
supported
USB device is detected,
but does not function
USB device drawing too
much current
USB device not
recognized
Hardware error
Hardware error
Write protection of the
PC card is activated.
Error when loading a
new firmware version.
Firmware does not work
with hardware version
Error recovery
for direct thermal
printing remove ribbon
for thermal transfer
printing set the printer in
the configuration or in
the software to transfer
printing
Reformat memory card.
Format card,
use another card type.
Do not use USB device.
Do not use USB device.
Do not use USB device.
Switch printer off and on
again.
If it occurs again →
Service.
The voltage which has
failed is displayed. Please
note this.
Repeat write attempt.
Reformat card.
Deactivate write
protection.
Load appropriate
firmware.
16-9