Backfeed; Media Loading - QuickLabel Systems pronto! 486 User Manual

Backfeed

In cut mode, the media will be stopped in a position where the leading edge
of the following label has already been moved beyond the printhead. The
printer can backfeed the label material from its cut position to the printhead.
Therefore, the next label can be printed completely.
A backfeed will always be performed if the parameter is set to "always". If the
setting is set to "smart", the backfeed will only be performed if the front label
is in its cut position and the printer has not yet received all of the data for
printing the following label. Otherwise, the print of the second label will be
started, but it will only be completed after the first label has been cut.

Media Loading

Load the transfer ribbon as described in Chapter 6: Loading media.
Load the label media for cut mode similar to the way it would be loaded for
tear-off mode.
Place the media strip between the printhead and the drive roller, so that the
beginning of the strip reaches into the cutter.
9-8 CU4 Cutter Accessory