Inverter Id - Delta RPI M6A Installation And Operation Manual

8 Settings
8.6

Inverter ID

Overview
With this function you can set an ID for the inverter. The inverter ID is used to identify the inverter in a RS485 connection. The inverter
ID is also used in monitoring systems.
► Set a different inverter ID for each inverter in the PV plant. Otherwise, the inverters cannot be correctly identified.
► On the last inverter in the RS485 connection, switch on the RS485 termination resistor. For a description, see
"6.6 Connecting communication port I", p. 58.
Accessing the menu
Main menu > Install Settings > Inverter ID
1 0 . S e p 2 0 1 4 1 5 : 3 2
S t a t u s : O n G r i d
P o w e r :
E - T o d a y :
I n v e r t e r I n f o .
G e n e r a l S e t t i n g s
I n s t a l l S e t t i n g s
A c t i v e / R e a c t i v e P w r
F R T
W a r n i n g :
A d j . w o u l d e f f e c t
e n e r g y p r o d u c t i o n
P a s s w o r d : * * * *
I n v e r t e r I D :
I n s u l a t i o n
C o u n t r y
G r i d S e t t i n g s
S e t t i n g I D :
I D = 0 0 1
Configurable Parameters
Parameter
Setting ID
70
1.
When the default information is displayed, press any button to open the main menu. Oth-
erwise, repeatedly press the button
0 W
0 k W h
2.
Use the buttons
To confirm your selection, press the button
3.
The menu is protected by password 5555. Use the buttons
To confirm a digit, press the button
4.
0 0 1
Use the buttons
displayed behind the menu entry.
To confirm your selection, press the button
5.
Use the buttons
To confirm your setting, press the button
Description
Sets the inverter ID that is needed to identify the inverter when a PV
plant contains multiple inverters.
until the main menu is displayed.
ESC
and to select Install Settings.
.
ENT
.
ENT
and to select Inverter ID. The currently set inverter ID is
.
ENT
and to set the inverter ID.
.
ENT
Installation and Operation Manual for RPI M6A M8A M10A inverters V1.0 2016-02-03
and to set each digit.
Value range
001 ... 254