ZyXEL Communications GS-3012 User Manual page 218

GS-3012/GS-3012F User's Guide
bpdu-control
cable_diagnostics
dlf-limit
egress set
exit
flow-control
frame-type
gvrp
help
igmp-filtering
profile <name>
igmp-group-limited
igmp-group-limited
number <number>
igmp-immediate-
leave
igmp-querier-mode
<auto|fixed|edge>
inactive
30-24
Table 30-5 Command Summary: Interface
COMMAND
<peer|tunnel|discard|network> Sets how Bridge Protocol Data
<pkt/s>
<port-list>
<all|tagged>
DESCRIPTION
Units (BPDUs) are used in STP
port states.
Displays whether a cable is
connected to the port (good) or
not (open).
Enables the Destination Lookup
Failure (DLF) limit.
Sets the interface DLF limit in
packets per second (pps).
Sets the outgoing traffic port list
for a port-based VLAN.
Exits from the interface
configuration command set.
Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
Choose to accept both tagged
and untagged incoming frames
or just tagged incoming frames
on a port.
Enables this function to permit
VLAN groups beyond the local
switch.
Displays a description of the
interface commands.
Sets the IGMP filtering profile for
this port.
Limits the number of multicast
groups.
Sets the number of multicast
groups this port is allowed to join.
Enables IGMP immediate leave
on the port.
Sets the IGMP querier mode of a
port. auto uses the port as an
IGMP query port after it receives
IGMP query packets. fixed
always uses the port as an IGMP
query port. edge stops the
switch from using the port as an
IGMP query port.
Disables the specified interface
on the switch
Introducing the Commands