ZyXEL Communications GS-3012 User Manual page 214

GS-3012/GS-3012F User's Guide
snmp-server
spanning-tree
spq
ssh
storm-control
syslog
30-20
Table 30-3 Command Summary: Configure Mode
COMMAND
ssh <socket-number>
telnet <socket-
number>
[contact <system
contact>] [location
<system location>]
get-community
<property>
set-community
<property>
trap-community
<property>
trap-destination
<ip>
<port-list>
<port-list>
priority <0-255>
<port-list> path-
cost <1-65535>
hello-time <1-10>
maximum-age <6-40>
forward-delay <4-
30>
priority <0-61440>
known-hosts <host-
ip> <1024|ssh-
rsa|ssh-dsa> <key>
<cr>
server <ip> inactive
level <0-7>
DESCRIPTION
Allows SSH access on the
specified service port.
Allows Telnet access on the
specified service port.
Sets the geographic location and
the name of the person in charge
of this switch.
Sets the get community.
Sets the set community.
Sets the trap community.
Sets the IP addresses of up to four
stations to send your SNMP traps
to.
Enables STP on the switch.
Enables STP on a specified port.
Sets the priority for a specified
port.
Sets the STP path cost for a
specified port.
Sets Hello Time, Maximum Age
and Forward Delay.
Sets the bridge priority of the
switch.
Sets the queuing method to SPQ
(Strictly Priority Queuing).
Adds a remote host to which the
switch can access using SSH
service.
Enables broadcast storm control
on the switch.
Enables syslog.
Disables a syslog server entry.
Sets which severity level(s) of logs
are sent to this syslog server. A
lower number is more critical.
Introducing the Commands