Mitsubishi Electric meiki series Instruction Manual page 15

KN51051BA英仏_英 10.10.18 0:49 PM ページ 13
――――――――― INSPECTION AND SERVICE AT EVERY 50-HOUR ―――――――――
Cleaning and adjustment of ignition plug
After removing carbon accumulated on
the electrodes and the insulator, adjust
the clearance between the electrodes at
0.6 ~ 0.7 mm
When mounting the plug cap, push
it in securely.
Clearance
between
electrodes
0.6 ~ 0.7 mm
Remove carbon from the muffler in-/outlet, cylinder and piston.
This work requires engine servicing skill and some tools. Consult the dealer or nearest
service center.
――――――――――――
Disconnect the ignition plug wires before inspection or adjustment to prevent unexpected
start of engine.
Do not touch the engine immediately after operation to prevent burn.
Use of fire is strictly prohibited when handling the fuel (gasoline).
Make sure to clean spilled fuel sufficiently before using the engine.
Do not wash the engine with water.
Do not change the setting revolution speed carelessly. (Consult your dealer when
changing the revolution speed.)
Plug cap
Carbon removal
CAUTIONS DURING INSPECTION ――――――――――――
― 13 ―
Cleaning of fuel filter
Using a piece of wire, or the likes, pull
out the fuel filter and wash with clean
white kerosene. When it is fouled
heavily, replace the filter and also wash
the tank inside.
Use of fire is strictly prohibited
Fuel filter