Evaporator Cover; Evaporator Fan - Viking VCFF136D Service Manual

Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.

Evaporator Cover

1. Remove upper bins (see supper bin section,
page 59).
2. Remove freezer door and rail assemblies (see
freezer door and rail assembly section, page 60).
3. Remove left and right glide adapters (see glide
adapter section, page 60).
4. Remove freezer thermistor cover (see freezer
thermistor section, page 61).
5. Remove evaporator fan cover.
6. Remove securing screws and evaporator cover.
Screw
With the evaporator cover removed, the
evaporator fan, the freezer thermistor, defrost
heater, and defrost thermostat are accessible.
7. Reverse procedure to reinstall.
© 2010 Viking Preferred Service
WARNING

Evaporator Fan

The unit uses a fan motor to pull air over the
evaporator coil and circulate it throughout the unit.
Evaporator Fan access:
1. Remove upper bins (see supper bin section,
2. Remove freezer door and rail assemblies
3. Remove left and right glide adapters (see glide
4. Remove evaporator cover (see evaporator cover
5. Remove securing screws.
Evaporator
Fan Cover
page 59).
(see freezer door and rail assembly section,
page 60).
adapter section, page 60).
section at left).
Screw
62