Viking VCFF136D Service Manual page 64

Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
7. Pull evaporator assembly forward to release
from rear wall connectors.
Connector
8. Disconnect wiring on both ends of heater.
Wiring
© 2010 Viking Preferred Service
WARNING
9. Release clips to remove heater.
Connector
10. Repair or replace defrost heater.
11. Reverse procedure to reinstall.
Wiring
Clip
64