Evaporator Cover; Evaporator Fan - Viking RDDFF236 Service Manual

Service Diagnostics and procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.

evaporator Cover

1. Remove freezer drawer, baskets, and glide
adapters (see Freezer Drawer, Baskets, Bins
Glides and Glide Adapters section,
pages 39-42).
2. Remove freezer thermistor cover (see Freezer
Thermistor section, page 46).
3. Remove evaporator fan cover.
4. Remove securing screws, wiring harness and
evaporator cover.
Wiring Harness
With the evaporator cover removed, the
evaporator fan, the freezer thermistor, defrost
heater, and defrost thermostat are accessible.
5. Reverse procedure to reinstall.
© 2012 Viking Preferred Service
WARNING

evaporator Fan

The unit uses a fan motor to pull air over the
evaporator coil and circulate it throughout the unit.
Evaporator Fan access:
1. Remove freezer drawer, baskets, and glide
2
Evaporator
3. Remove securing screws.
Fan Cover
Screw
adapters see Freezer Drawer, Baskets, Bins
Glides and Glide Adapters section,
pages 39-42).
Remove evaporator cover (see Evaporator
Cover section at left).
Screw
47