Barbecook VANILLA 223.9988.000 Installation Instructions Manual page 26

E
that could block gas flow in whole or in
part. Such a situation is indicated by a
smoky, yellow flame and/or burner that
can only be lighted with difficulty or not
at all. The gas may eventually burn
outside the venturi tube and thus cause
serious damage to your barbecue.
Should this happen, immediately close
the cylinder. Clean the burners as soon
as the barbecue has cooled down.
Remove the burner(s) as shown in Fig.
F. Clean with a pipe cleaner or brush
both venturi tubes. Put the burner
back into place in accordance with the
instructions. (Fig. F) After cleaning, the
venturi tubes must be correctly placed
back over the openings of the gas
valves.
Note: damage arising from a fully or partly
blocked venturi tube in a burner is not cov-
ered by the guarantee and is considered
lack of proper maintenance
F
.
LIGHTING THE BURNERS
Prior to lighting the burners, all checks and
procedures detailed in the chapter 'Before
the first use' must have been carried out.
• The lid of the barbecue must always
be open when you light the burner(s)
• Do not bend directly over the barbe-
cue when lighting the burner(s)
• The control knobs of the barbecue
must be 'OFF'. Slowly open the gas
cylinder valve. Before opening the
control knob of one burner, wait ap-
prox. 10 seconds to allow to gas to
stabilize
• Important: first light the middle bur-
ner
• As soon as one burner has been
lighted, you only need to put the con-
26 www.barbecook.com
trol knob of the other burner(s) in the
position 'HIGH' to light them.
• Never try to light all burners at once
LIGHTING THE BURNERS WITH THE
IGNITER
• Open the lid of the barbecue
• Open the gas cylinder valve.
• Press the igniter until you hear
sparks
• Holding down the igniter, press the
control knob of the middle burner
and turn to 'HIGH'
• If the burner does not light after 3
attempts, disconnect the gas and
wait 5 minutes before trying again.
This will allow the accumulated gas
to escape. Try again, repeating the
above steps.
• If the burner still does not light, read
the chapter 'Troubleshooting Guide'
to determine the cause and the
remedy, or use a match as described
below.
G
LIGHTING THE BURNERS WITH A
MATCH
Left and right at the bottom of the burner
box is a small opening that can be used to
light the burners with a match, if the elec-
tronic igniter does not work. (Fig. G)
• Open the lid of the barbecue
• Place a match in the match holder
provided (Fig. G)
• Hold a burning match through the
hole, approx. 13 mm from the burner
• Open the gas cylinder valve.
• Push the required control knob and
turn to 'HIGH'. The burner should
light within 5 seconds. If not, turn the
control knob off and wait 5 minutes
to allow the gas to escape.
• Repeat steps 1 through 5. If the
burner still does not light after 3
attempts, read the chapter 'Trouble-
shooting Guide'
LIGHTING THE OTHER BURNERS
• As soon as the middle burner has
been lighted, you only need to
put the control knob of the other
burner(s) in the position 'HIGH' to
light them.
LIGHTING THE SIDE BURNER USING
THE IGNITER
Only for Vanilla
First open the lid of the side burner.
To light the side burner, use the igniter on
the control panel and the control knob on
the side table.
• Press the igniter until you hear
sparks.
• Holding down the igniter, press the
control knob of the side burner and
turn to 'HIGH'
• Repeat a number of times if the
burner does not light immediately.
• If the burner does not light after 5 se-
conds, turn the control knob to 'OFF'
and wait 5 minutes to allow the gas
to escape.
• Repeat steps 1 through 3. If the
burner still does not light, read the
chapter 'Troubleshooting Guide' or
use a match as described below.
Note:
• the maximum load of the side burner
is 9 kg!
• the maximum diameter of the cooking
vessel is 220 mm
H
LIGHTING THE SIDE BURNER WITH A
MATCH
Only for Vanilla
• Place a match in the match holder
provided
• Hold a burning match approx. 13
mm from the burner (Fig. H)
• Push the control knob of the side
burner and turn to 'HIGH'. The bur-
ner should light within 5 seconds. If
not, turn the control knob 'OFF' and
wait 5 minutes to allow the gas to
escape.