Manual Speaker Test - Russound MCA-C5 Service Manual

1. Click the "Disconnect All" button on RVCLIScripter.
2. Turn off the MCA-C5.
3. Remove 240V AC power from the MCA-C5.
4. Set the AC100V~/AC240V~ switch to AC100V~ on the MCA-C5.
5. Connect 100V AC to the MCA-C5.
6. Turn on the MCA-C5 and watch MDK-C5's to confirm bootup.
7. Click the "Connect All" button on RVCLIScripter.
8. Click the "Clear" button in the "Command Queue" window.
Expand the "Speaker Outputs" script.
Right click the "Speaker Outputs" script and left click "Load Test".
9. Click the "Send" button to the right of the "W 8.0.3 17" command.
The Logging window to the right will display an "S" below the "W 8.0.3 17"
Command, this may take a few seconds, which shows the command was
successfully processed by the MCA-C5.
10. Connect the Speaker cable to the Speaker Outputs number 1 of the MCA-C5.
11. Press the "Power" button on the Zone 1 MDK-C5 Keypad.
12. Zone 1 MDK-C5 Keypad will illuminate and display the FM dial set at 99.5.
All other Zones MDK-C5 Keypads will be off (dark).
Raise and Lower the volume on the Zone 1 MDK-C5 Keypad.
You will hear and view undistorted tuner Audio from the speakers.
Press the "Power" button to turn off the Zone 1 MDK-C5.
13. Unplug the Speaker cable MCA-C5 Speaker Outputs number 1.
Plug the Speaker cable into the MCA-C5 Speaker Outputs number 2.
14. Press the "Power" button on the MDK-C5 connected to Zone 2.
Zone 2 MDK-C5 will illuminate and display the FM dial set at 99.5.
All other Zones MDK-C5 will be off (dark).
Raise and Lower the volume on the Zone 2 MDK-C5 Keypad.
You will hear and view undistorted Tuner Audio from the speakers.
Press the "Power" button to turn off the Zone 1 MDK-C5.

Manual Speaker Test

MCA-C5 Test Procedure
Rev 1.5
Page 65 of 78