Table of Contents
Advertisement
Channel Settings
This menu is used for input related settings. Select the "Select Channel" item and choose a channel number from CH1
to CH30. Finally define the parameter of each of the "Channel Settings".
Item
Select Channel
Input Configuration
Select Input Signal
Format
Internal Sync
Channel Name
Picture Mode
Setting Options (underline indicates factory default)
Displays the channel number. In addition, you can assign each content of "Channel Settings" to each
channel (
50).
CH1 to CH30
Note
• It may take 10 seconds when switching channels.
Select the input. Factory default depends on the channel (
3G/HD-SDI 1, 3G/HD-SDI 2, Dual Link HD-SDI, DisplayPort, — (Not set)
Sets the signal display method (
Automatic: "4K Input" and "Single Input" are automatically determined.
4K Input: Displays the signal transmitted over four inputs.
Single Input: Displays the signal of a single input onto the center of the screen. Select from A to D.
Sets the color format and gradation.
Automatic, 4:2:2 YCbCr 10-bit, 4:2:2 YCbCr 12-bit, 4:4:4 YCbCr 10-bit,
4:4:4 YCbCr 12-bit, 4:4:4 RGB 10-bit, 4:4:4 RGB 12-bit, 4:4:4 XYZ 12-bit
Note
• HD-SDI is fixed to "4:2:2 YCbCr 10-bit".
• DisplayPort is fixed to "Automatic".
• Operations when "Automatic" is selected are described below:
-
When "4K Input" is selected, they are rendered in a Payload that is selected in the order of
priority A → B → C → D in the display area.
-
When receiving 3G-SDI or Dual Link HD-SDI input, all signals without a payload format will
be rendered in "4:4:4 RGB 10-bit".
Synchronizes four inputs for "4K Input".
On: Force synchronization.
Off: Do not force synchronization.
Sets the name of the selected channel. You can input up to 16 alphanumeric characters.
Sets the "Picture Mode".
50).
16).
OSD Menu
49
Advertisement
Table of Contents
