Table of Contents
Advertisement
Re-pairing
To pair a display and the display controller again for example when a paired display controller is reconnected.
1. Connect the main unit to the display controller (
2. Enable communication between the main unit and the display controller.
Reset the network settings of the main unit.
To reset the pairing information, press and hold the main unit's F3 and F4 buttons simultaneously for about
3 seconds until the power indicator flashes green. "Configure an IP Address" is set to "Automatic".
Reset the network settings of the display controller.
To reset the pairing information, press and hold the display controller's buttons, and SET buttons
simultaneously for about 3 seconds until the power indicator flashes green. "Configure an IP Address" is set to
"Automatic". "Display List" is also reset.
When resetting of pairing information is finished for both units and re-pairing is complete, the power indicator of the
display controller lights green.
Note
• Directly pair the main unit and the display controller and then connect to your network environment. Correct pairing may
not be possible when multiple devices are connected to the network.
• If the button brightness setting of the display controller is sets to "Off", it will not turn on when pairing completes. Set the
button brightness to 1, 2 or 3 if you want to verify when pairing completes (
• Manually configure the "IP Address" and "Subnet Mask" as necessary (
24
Pairing
19).
13).
64).
Advertisement
Table of Contents
