Table of Contents
Advertisement
Item
LUT Delete
YCbCr Color
Matrix
2020 Gamut
Mapping
Calibration
Copy
Picture Mode
Picture Mode
Name
Anchor Adjustment
Reset
46
OSD Menu
Setting Options (underline indicates factory default)
Deletes imported LUT.
LUT Type (Gamma, Color Gamut): Select the LUT type.
Select LUT: Selects User LUT 1-8.
Delete: Deletes LUT.
Sets the matrix conversion method for input signals in YCbCr format.
Automatic: Matrix coefficient is set in conformance with the ITU-R BT.2020 standard when the
"Picture Mode" or "Color Gamut" setting is "ITU-R BT.2020" and in conformance with the ITU-R
BT.709 standard otherwise.
ITU-R BT.709: Matrix coefficient is set in conformance with the ITU-R BT.709 standard.
ITU-R BT.2020: Matrix coefficient is set in conformance with the ITU-R BT.2020 standard.
Set this item when "ITU-R BT.2020" is selected for "Picture Mode" or when "User 1-7" or "Canon
Log" is selected for "Picture Mode" and also "ITU-R BT.2020" is selected for "Color Gamut".
Gamut Mapping: Mapping is performed on colors outside the native color gamut by Canon's
unique method.
Clipping: Colors outside the native color gamut are clipped by a general method.
Performs calibration based on set target values when "User 1-7" is selected for "Picture Mode".
Luminance: Sets the target luminance.
2
48 to 200 cd/m
Color Temperature: Sets the target color temperature.
D93, D65, D61, D60, D56, D50, DCI-P3: Select from preset color temperatures.
Custom (xy): You can adjust CIE x, y in increments of 0.001.
x: 0.260 to 0.360 (0.314)/y: 0.260 to 0.360 (0.351)
Color Gamut: Sets the color gamut.
SMPTE-C, EBU, ITU-R BT.709, ITU-R BT.2020, Adobe RGB, DCI-P3
Gamma: Sets the target gamma.
2.2, 2.35, 2.4, 2.6, ITU-R BT.1886
Start: Performes calibration.
Note
• When "Luminance" is set to high brightness, it may be calibrated beyond the brightness
adjustment range and set lower than the target value depending on the "Color Temperature"
setting. In that case, set the "Luminance" again.
When "User 1-7" is selected for "Picture Mode", the content of the selected picture mode is copied.
The following modes can be selected:
Picture Mode: SMPTE-C, EBU, ITU-R BT.709, ITU-R BT.2020, Adobe RGB, DCI-P3, User 1-7
(other than the currently set parameter)
Execute: Performs copy.
You can change the name of "User 1-7" within 16 characters including alphabetical characters,
numbers, and symbols.
Temporarily saves parameters while adjusting SHARPNESS, CHROMA, BRIGHTNESS, and
CONTRAST (anchor point setting).
OK: Performs anchor point setting.
Cancel: Returns to the previous screen without setting anchor point.
Return "Picture Mode" to factory default. Note that in "User 1-7" mode where you are performing
calibration, the setting returns to the value after calibration instead of the factory default.
When selected, the message "Reset Adjustment settings to defaults?" appears.
OK: Performs reset.
Cancel: Returns to the previous screen without resetting.
Advertisement
Table of Contents
