Table of Contents
Advertisement
Pairing
To operate the main unit using the display controller, the main unit needs to be registered (paring) to the display
controller.
Pairing the Main Unit with the Display Controller
1. Connect the main unit to the display controller (
2. Turn on the power of the main unit ("Turning on the Power of the Main Unit"
This automatically completes pairing and the power indicator of the main unit flashes green and the power indicator
of the display controller also lights green.
Note
• Directly pair the main unit and the display controller and then connect to your network environment. Correct pairing may
not be possible when multiple devices are connected to the network.
• If the button brightness setting of the display controller is sets to "Off", it will not turn on when pairing completes. Set the
button brightness to 1, 2 or 3 if you want to verify when pairing completes (
• Manually configure the "IP Address" and "Subnet Mask" as necessary (
■ Controlling multiple displays using one display controller
Connected displays are registered to F buttons (F1 to F10) of the display controller in ascending order from F1. Up to
ten displays can be registered. You can change the display to be controlled by following the procedures below.
1. Connect the display to be controlled to the display controller.
2. Turn on the power of the display.
3. Press the F button the display is registered to while holding down the SET button of the display controller.
The power indicator of the display flashes green and the power indicator of the display controller lights green.
Note
• You can check the displays registered to F1 to F10 buttons in "Display List" under "System Settings" (
a display registered to an F button or register a display to a different button.
19).
13).
64).
22).
65). You can cancel
Pairing
23
Advertisement
Table of Contents
