Canon dp-v3010 Instruction Manual page 61

Item
Wave Form Monitor
Enable
Select Signal
Display Type
Position
Guide
Standard
Level High
Standard
Level Low
Color
Setting Options (underline indicates factory default)
Wave Form Monitor is displayed for SDI signals. On the wave form monitor, the horizontal axis shows
the horizontal resolution of the video and the vertical line shows the signal level.
Signal level
Note
• "Wave Form Monitor" is not displayed in the following cases:
-
When "Frame Hold" or "False Color" is "On",
-
When "Peaking 1" or "Peaking 2" is selected
-
During the execution of "Playback File" under "Screen Capture"
-
When a "Test Pattern" is displayed
-
When "H Delay"/"V Delay" is "On"
• When "Wave Form Monitor" is "On", "Vector Scope" is "Off".
Switches the wave form monitor On, Off.
On, Off
Sets the wave form to be displayed.
Y, Cb, Cr, R, G, B
Sets the display type. When "Line" is selected, data for one line is displayed.
All, Line
Selects the line to be displayed when "Line" is selected.
Select Line: 1 to 2160
Selects the display position.
Bottom Left, Bottom Right
A guide is displayed at the specified position. "Guide" is not displayed when "255" is selected.
1 to 255
Sets the standard display level (high). "Standard Level High" is not displayed when "255" is selected.
190 to 255
Sets the standard display level (low). "Standard Level Low" is not displayed when "0" is selected.
0 to 64
Sets the signals to be displayed and the color of signals exceeding the standard level.
Y, Cb, Cr, R, G, B: Selects the signal.
Selects the color of the selected signal.
White, Red, Green, Blue, Yellow, Cyan, Magenta
Default value of each signal is shown below.
Y (White), Cb (White), Cr (White), R (Red), G (Green), B (Blue)
Standard Level High, Standard Level Low: Selects the standard level.
White, Red, Green, Blue, Yellow, Cyan, Magenta
Default value of each standard level is shown below.
Standard Level High (Magenta), Standard Level Low (Cyan)
255
0
Horizontal resolution of video
100%
50%
0%
-4%
OSD Menu 61