Connecting The Printer To A Power Source - Intermec EasyCoder 4420 User Manual

Chapter 1 — Getting Started

Connecting the Printer to a Power Source

6
C d 39
The back of the printer contains the AC power cord receptacle, the serial
communications port, the parallel communications port, the accessory
port, the darkness adjust, the On/Off switch, and two banks of DIP
switches.
To connect the printer to a power source
1Turn off the printer.
*
*2 Make sure the DIP switches on the back of the printer are set to their
factory default settings.
Top Bank Turn on switch 1. Turn off switches 2 through 8.
*Bottom Bank Turn off switches 1 through 8.
3Plug the AC power cord into the receptacle at the rear of the printer.
*
*4 Plug the other end of the power cord into a grounded wall outlet or
surge protector.
*5 Turn the printer on.
When you turn on the printer, the green light emitting diode (LED) lights
and the platen roller advances. The yellow LED lights until you load
media.
EasyCoder 4420 and 4440 Bar Code Label Printer User's Manual
Helvetica
Helvetica Condensed
I
I
O
I
O
O
44XXU005.eps