Sandstrom SDW60GW13 Instruction Manual page 6

WARNING
IT IS HAZARDOUS FOR
ANYONE OTHER THAN
AUTHORISED SERVICE
PERSONNEL TO CARRY OUT
SERVICING OF REPAIRS
WHICH INVOLVE THE
REMOVAL OF COVERS.
TO AVOID THE RISK OF AN
ELECTRICAL SHOCK DO
NOT ATTEMPT REPAIRS
YOURSELF.
• Do not sit or stand on the door or
dish rack.
• Do not move your dishwasher
by holding the door or its edges.
Hold the dishwasher around its
sides or base when moving it.
• Do not touch the heating
element during or immediately
after use.
• Do not operate your dishwasher
unless all enclosure panels are
properly in place. Open the door
very carefully when there is a
programme running, as there is a
risk of hot water spraying out of
the appliance.
• Do not place any heavy objects
on the open door. The appliance
could tip.
• When loading items to be
washed:
• Locate sharp items so that they
will not damage the door seal;
• Warning: Knives and other
utensils with sharp points must
be loaded in the basket with the
points downwards or placed
horizontally.
6
• Do not allow plastic items to
come into contact with heating
element.
• Check that the detergent
receptacle is empty after
completion of the wash cycle.
• Do not wash plastic items unless
they are marked dishwasher safe
or equivalent.
• Use only detergent and rinse
aids designed for an automatic
dishwasher.
• Other means for disconnection
from the supply must be
incorporated in the fixed wiring
with at least 3mm contact
separation in all poles.
• The door should not be left in the
open position since this could
present a tripping hazard.
• For energy saving, always
remember to switch the
dishwasher off when you have
finished using it. The dishwasher
should not be left unattended
when in use.
• Remove the door to the washing
compartment when removing an
old dishwasher from service or
discarding it.
• During installation, the power
supply cord must not be
excessively or dangerously bent
or flattened.
• Do not tamper with controls.
• The appliance is to be connected
to the water mains using new
hose sets.
• The maximum number of place
settings to be washed is 14.
• The maximum permissible inlet
water pressure is 1Mpa, and the
minimum permissible inlet water
pressure is 0.04Mpa.