Frost Precaution; Moving The Dishwasher - Sandstrom SDW60GW13 Instruction Manual

Spray Arms
Particles of food can get stuck in the spray
arm jets and bearings. The spray arms should
therefore be checked and cleaned regularly.
1. Switch off the unit.
2. Remove the middle spray arm by holding the middle joint firmly. Turn the spray arms to
remove.
3. Remove the lower spray arm: Grab firmly and pull upwards
4. Wash the spray arms in warm soapy water. Use a soft brush to clean the jets.
5. Rinse thoroughly, then replace the spray arms.
The top spray arm can NOT be removed.

Frost Precaution

Avoid placing the dishwasher in a location where the temperature can get below 0˚C. If your
appliance is left in an unheated place over the winter, you are advised to:
1. Disconnect the unit from the water inlet.
2. Turn on the unit. Select any washing cycle and let it run for 1 minute only. This drains out all
the excessive water that remains in the unit.
3. Disconnect from the mains socket.
4. Empty the dishwasher.
5. Close the dishwasher's door.
6. Disconnect the unit from the water drain. Use a suitable receptacle to catch any residual
water in the pipes.
Should you encounter any difficulties with the above steps, please ask a qualified service agent
for assistance.

Moving the Dishwasher

If you have to move the unit, for instance due to moving house, you are advised to:
• Disconnect the dishwasher from the mains socket.
• Disconnect the dishwasher from the water inlet and drain. Use a suitable receptacle to
catch any residual water in the pipes.
• Remove the dishwasher from the current location with the hoses discharged.
• Pull the unit out together with the hoses.
• Avoid over tilting the unit during transportation.
• 2 people are required to handle the dishwasher during installation.
30