Sandstrom SDW60GW13 Instruction Manual page 10

INSTALLATION
1. Make sure your plumbing is suitable
for use with the dishwasher. If in doubt
contact a qualified plumber. This unit
MUST BE connected to COLD WATER
MAINS using the new water inlet hose.
OLD HOSE SETS MUST NOT BE RE-USED.
The water pressure from the water mains
needs to be at a minimum of 0.04 MPa
and a maximum of 1.00MPa.
• Connect one end of the safety water
supply hose to your dishwasher, and
then connect the other end of the
hose to your water mains. Please
ensure the black rubber seal is in place.
• After connecting the hose, turn on
your water mains and check for leaks.
• Connect the dishwasher to the mains
socket.
You may use a Y-Adaptor (not included)for an additional water feed for another appliance, for example
a washing machine. This is only applicable for cold water mains. A Y-Adaptor is available from most DIY
stores.
10
Water mains
Y-Adaptor
(not included)
Connect
to another
appliance
if required.
Water supply hose