Elation Event Brick W System Manual page 35

To start a Auto Program please proceed as follows:
1. Slave-Setting
• Select "Function Mode" by turning the encoder.
• Press the Enter button to confirm.
• Select "Set to slave" by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select "Slave 1", "Slave 2" or "Slave 3".
• Press the Enter button to confirm.
• Press the Mode/Esc button in order to return to the main menu.
2. Automatic Program Run
• Select "Function Mode" by turning the encoder.
• Press the Enter button to confirm.
• Select "Auto Program" by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select "Master" or "Alone". The selection "Alone" means Stand
Alone-mode and "Master" that the device is defined as master.
• Press the Enter button to confirm.
• Press the Mode/Esc button in order to return to the main menu.
3. Program selection for Auto Pro Part
• Select "Edit program" by turning the encoder.
• Press the Enter button to confirm.
• Select "Select programs" by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select "Auto Pro Part 1", "Auto Pro Part 2" or "Auto Pro Part 3", and
thus select which Slave program is to be sent. Selection "Part 1" means, that the
Slave unit runs the same program as the master units.
• Press the Enter button to confirm.
• Press the Mode/Esc button in order to return to the main menu.
©Elation Professional® 35
Event Brick System™
Event Brick System™