Elation Event Brick W System Manual page 11

well as diffuse the light output.
3. Lens Cover – This cover the LED assembly and hold the frost filters in place. To
remove the frost filters, turn the lock screws in counter-clockwise direction ¼ turn.
4. Bracket Knob – This knob is used to secure the bracket in place.
5. Bracket Locking Knob – This knob is used to secure the bracket in place after
angle adjustments have been made.
6. Battery Power Input - This jack is used to supply the fixture with power from the
external battery pack. NEVER attempt to run the fixture on battery power when
the battery pack is plugged into wall power.
7. On/Off Power Switch – Controls main power to the unit.
8. Power Output Jack – Use this jack to jump power to another Design LED 12 Brick™
in an array system.
9. Power Input/Fuse Holder Assembly – This assembly holds the safety fuse as well
as provides a female IEC connector for a power cord. A 2A/250v GMA fuse is
designed to protect the electronics in the event of severer power fluctuations. Never
defeat this fuse. In the event of fuse failure, always be sure to replace with an exact
match fuse unless other wise specified by an authorized Elation Professional
technician. Using a fuse other than that specified could seriously damage the unit
and will void your manufactures warranty.
10. Eye-Bolt – SAFETY CABLE RIGGING POINT –The fixture provides a built-in rigging
point for a safety cable. Be sure to use this point and never secure a safety cable to a
hanging bracket.
11. LED Menu Display – Four segment LED menu display, details all menu functions.
©Elation Professional® 11
Event Brick System™
Event Brick System™