Elation Event Brick W System Manual page 25

CHS7
CHS8
CTRL
MIC
DIMR
WDMX
LOAD
VER
Select
Programs
Edit Program
Edit Scenes
Rec. Controller
Remarks:
1) If the fixture does not receive a DMX signal the menu display will flash
repeatedly.
2) SPED: Adjust the hold time for each scene in built-in chase programs.
3) FADE: Adjust the fade time between each scene in the built-in programs.
©Elation Professional®
SPED
FADE
STRB
SPED
FADE
STRB
MAST
Sound-controlled run as Master
ALON
Sound-controlled run in Stand Alone
M-XX
Microphone sensitivity
Standard - Fixture will function with a stepping dimmer rate
MOD1
MOD2 Linear - Fixture will function with a dimming rate of 0~100%
ON Wireless mode
OFF No wireless mode
RESET Reset wireless info.
This function will allow the DMX signal to travel through the
wired DMX "Output" connections
Send
yes Reset to Fixture to the Factory Default Settings
V 1.0 "X.X' will represent the fixture's current firmware version
Auto Pro Part 1 Program 1 ~ 10 Program 1
Auto Pro Part 2 Program 1 ~ 10 Program 2
Auto Pro Part 3 Program 1 ~ 10 Program 3
Program 1 Program Test
: Step 01=SCxxx
Program 10 Step 64=SCxxx
Edit Scene 001 Pan,Tilt,......
~ Edit Scene --Secne Time--
250 Input
Outside
XX~XX
001-255 Set speed of scene
001-255 Set speed of fade
000-255 Set value of strobe
001-255 Set speed of scene
001-255 Set speed of fade
000-255 Set value of strobe
("STEP
XX")
Pan=xxx...
...
By TIME=xx.x
s
25
Event Brick System™
Select programs to be
run
Testing program
Program in loop
Save and exit
Save and automatically
return
Manual scenes edit
Automat. scenes rec
Event Brick System™