EonStor S12S -G1033/P Installation and Hardware Reference Manual
On receiving and unpacking your subsystem, please check the
package contents against the included Unpacking List. If any
module is missing, please contact your subsystem vendor
immediately.
1.2
Chassis Overview
The subsystem chassis is an enhanced 2U storage chassis divided
into front and rear sections, which are respectively accessed through
front and rear panels. The enclosure is designed to be installed into a
rack or cabinet. Read the following sections for the components'
descriptions and locations in the subsystem.
Components accessed through the front panel are referred to as
"Front Panel Components" and components accessed through
the rear panel are referred to as "Rear Panel Components."
1.2.1
Front Panel Overview
The front section of the subsystem features a 4 x 3 layout for housing
twelve (12) 3.5-inch drives. Two (2) forearm handles on the sides of
the chassis help with retrieving the chassis from a rack cabinet. A
comprehensive LCD keypad panel provides access to all embedded
firmware functionalities.
The front view of the subsystem is shown below:
Figure 1-2: S12S-G1033 Enclosure Front View
˙
Drive bays with drive tray canisters: The subsystem comes
with twelve (12) drive bays in the front section of the chassis.
1-2
NOTE:
NOTE: