Attention For Operation - Contec CMS-60C Instructions Manual

If the users choose to turn on the synchronizing display function on computer, it would
probably take several seconds for the data to appear on the computer screen.(If there is no
data on the computer screen ,unplug USB data line , then repeat step "E" again .)
F. Charge
There are two kinds of charging methods:
a) Connect the device with computer by data line, then the device should be under charging state.
b) Connect the device with power supply by power adaptor, then the device should be under
charging state.
c) The five status of battery power are shown as follows:
the four status above shows
dynamically in turn
d ） When charging the battery in the state of power off, the sign of battery status still exists on the
screen, but it will disappear in about 60 seconds for saving power. However, the sign will appear
again if you press any button(power on/off excluded) at this moment.
If the alarm function is on, the device will provide high-priority alarm signal when the
battery is in low power status .Intermittent alarm will occur and the battery icon turns red in
the state of flashing.
High priority indicating that immediate operator response is required.

6.2 Attention for operation

A. Please check the device before using, and confirm that it can work normally.
B. The finger should be in a proper position (see the attached illustration of figure 3 for reference), or
else it may result in inaccurate measure.
C. The SpO sensor and photoelectric receiving tube should be arranged in a way with the subject' s
2
arteriole in a position there between.
D. The SpO sensor should not be used at a location or limb tied with arterial canal or blood pressure
2
cuff or receiving intravenous injection.
E. Do not fix the SpO
2
measure of SpO and pulse rate.
2
F. Excessive ambient light may affect the measuring result. It includes fluorescent lamp, dual ruby
light, infrared heater, direct sunlight and etc.
CMS-60C
Medical Test Supply
Power supply by battery only, and battery status is full
Low power alarm indication（Please charge the battery ）
sensor with adhesive or else it may result in venous pulsation and inaccurate
Battery status is not full
Battery status is draining away
Battery is under charging