Attention For Operation - Contec CMS50D+ Manual

F. Standby mode
If the measuring finger out of the device on the
measuring interface, The product will enter standby
mode when no signal is in the product within 5
seconds.
The device can't being enter standby mode when it is in
a state of storing.

6.2 Attention for Operation

A. Please check the device before using, and confirm that
it can work normally.
B. The finger should be in a proper position (see
C. the attached illustration of Figure 4 for reference), or
else it may result in inaccurate measure.
D. The SpO
should be arranged in a way with the subject's arteriole
in a position there between.
E. The SpO
limb tied with arterial canal or blood pressure cuff or
receiving intravenous injection.
F. Do not fix the SpO
result in venous pulsation and inaccurate measure of
SpO and pulse rate.
2
G. Excessive ambient light may affect the measuring
result. It includes fluorescent lamp, dual ruby light,
infrared heater, direct sunlight and etc.
sensor and photoelectric receiving tube
2
sensor should not be used at a location or
2
sensor with adhesive or else it may
2
22